A4 Pattern Vivid Flex Heat Transfer Vinyl 10 + designs to choose from
Vivid Flex heat transfer vinyl (i.e. T-shirt vinyl, Iron-on vinyl) comes with a heat activated adhesive on one side. The other side (which will be the exposed side upon application has a clear carrier sheet that provides a way to keep everything intact until application. All cuts will need to be mirrored (flipped) as you are cutting it from the reverse side. Vivid Flex heat transfer vinyl is compatible with all personal hobby and craft cutters and can be used on many blank products including shirts, hats, shoes, bags or most anything that can withstand the application of heat.
Also available in 300mm wide rolls.
Features
- A4 Sheet Size
- Washing Guide: Flip inside out, cold wash and hang dry
- Compatible with all craft cutters such as: Silhouette Cameo, Portrait, Curio, Cricut-all models, Brother Scan and Cut, Xyron, Craft ROBO, Graphtec, P-Cut, Roland, Janome etc
- Vinyl width tolerance -/+ 3-5mm
- Please note while we ensure to get the exact same vinyl colours each time please be aware that vinyl shades can change from time to time due to slight variances between batches, much like fabric colours can vary between rolls/batches.
Material Specification:
- PET Composition
- Thickness:145 Microns / 5.7 Mils (Please make sure plotter is capable of cutting such thickness)
- Heat pressure sensitive backing
- Special Design Finish
Application Instruction (Home Iron)
- Cut in reverse
- Weed excess material
- Set iron dial between Cotton and Linen
- Cover design with Kraft paper or non-stick cover sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 15-20 seconds
- If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
- let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.
- Layering: Possible with reduced times and temps on start layers
Application Instructions (Heat Press)
- Cut in reverse
- Weed excess material
- Preheat all fabric prior to pressing for best results
- Apply design at 150°c for 10-12 seconds
- Allow the transfer to cool for about 20 seconds and then gently peel back the clear plastic until it is completely removed.
- Layering: Possible with reduced times and temps on start layers
Applies to:
- 100% Cotton
- Poly / Cotton Blends
- 100% Polyester
- Leather
Washing/Care Instructions:
- Wait 24 hours before 1st wash
- Cold Machine wash with mild detergent
- Dry on normal dryer setting
- Do not bleach or dry clean